Accent 1400 Hardware Manual for Dedicated Devices
Page 21
Attaching the Device Frame More Securely
When you initially attach the frame, the sides rest against the sides of the device loosely. When you
insert a Keyguard into the frame, a user could pull hard on the Keyguard and pull it loose from the
frame. To prevent this from happening, secure the sides of the frame by pressing hard on each side until
it snaps into place.
For an Even More Secure Fit
If you do not expect to remove and reattach the frame to the device frequently, you may want to insert
the original screws in the top and bottom holes of the frame. If you expect to remove and reattach the
frame to the device frequently, you may not want to use the screws.
1.
Place the device face down on a flat surface.
2.
Insert the two small screws that you removed
earlier (page 19, “Removing the Frame”, step
2) through the holes in the top of the frame
and into the corresponding holes in the top
of the device.
3.
Insert the two larger screws through the
holes in the bottom of the frame and into
the corresponding holes in the bottom of
the device.
4.
Tighten all four screws with a Phillips
screwdriver.
When the Device Frame is Attached Securely
After you attach the frame securely to the device, you can attach a Keyguard or TouchGuide to the
frame. See “Attaching the Keyguard” on page 22 or “Attaching the TouchGuide” on page 24.
The sides now fit tightly against the device, and the
Keyguard cannot be pulled loose. Once you snap
the sides of the frame into place, they are designed
to hold securely.
Step 2
Step 3
