Alarm
52
Each triggered alarm you can handle individually:
Handle:
Parameter
Setting
Pop-up Image on Moni-
tor
A message appears on the
monitor.
Audio Warning
The device emits a repeat-
ing tone.
Notify Surveillance Cen-
tre
Sends an alarm signal to a
PC with ABUS CMS soft-
ware. The software must be
enabled and the recorder
set to surveillance mode on
the PC.
Send Email
An e-mail is sent to a spe-
cific e-mail address (see
page 49).
Trigger Alarm Output
See page 53.
Relay out deactivated
The relay outputs selected
here are closed when the
alarm input is reset. This
has no effect if the alarm
output is already closed.
Schedule:
Here you can define in which period of time the reaction
to the alarm input shall be handled.
Triggered Camera:
Parameter
Setting
Record
Using this parameter, you can select
which cameras should be used for re-
cording after the alarm input is trig-
gered.
Enable Sched-
ule
Using this parameter, you can select
on which cameras the schedule
should be activated. For example, if
you have installed the ABUS IP alarm
module, then you can use the
Secvest Key to activate guard mode
in the recorder when exiting the prem-
ises. The recording mode (duration,
motion detection, alarm) stored in the
schedule is then used. In this way,
you can activate the recorder inde-
pendently from the schedule and pre-
vent false alarms.
Ensure that the schedule is not acti-
vated initially so that it is not disarmed
during activation.
