Quick guide
Quick guide
Before you start
The following preparatory steps must be made:
1. Pay attention to the general information, safety in-
formation and notes on setting up and connecting
the device (see page 8).
2. Check the contents of the package for completeness
and damage.
3. Insert the batteries into the remote control.
Installing the HDD
Warning
Switch off the device and disconnect it from the
mains power supply.
Pay attention to the required earthing of the de-
vice to avoid static discharge.
1. Install the HDD. Use the data and power cable sup-
plied.
2. Firstly, establish the connection to the motherboard
using the red data cable (small connector).
3. Connect the power supply cable
(large 5-pin connector).
4. Check that the connections are secure.
5. Close the housing.
Establishing the connections
1. Connect the analogue cameras with BNC connec-
tions 1 to 4.
2. Connect the audio connections.
3. Connect the LAN connection on the device to the
network.
4. Connect the sensors to the alarm inputs.
5. Connect the monitor to the BNC connection.
6. Connect the mouse to the USB port.
7. Establish a connection to the mains power supply.
8. Switch on the device using the POWER switch on
the rear. The DVR status display on the front of the
device lights up.
Note
To connect a monitor with a VGA connection, use
the BNC-VGA converter (TVAC20000).
7
