PTZ control
Preset settings
Presets are previously defined locations of a PTZ cam-
era. Various positions can be defined for each PTZ cam-
era. The cameras can then pan and tilt quickly to the cor-
responding locations.
•
Select PTZ in the menu and click on Preset Settings:
1. Select a preset number between 1 and 128.
2. Select Adjust to change the position of the camera.
3. Right-click to exit the PTZ control and click on Save
to store the Preset position.
4. Repeat steps 1–3 to define further presets.
5. Finish your settings by pressing Return.
Patrol settings
Patrols are defined tours from position to position that are
accessed in sequence on the PTZ camera. The individual
positions are presets, which should be set as detailed be-
fore. The cameras can then each be moved in sequence
to the corresponding positions at a defined speed, where
they remain for a set period of time.
•
Select PTZ in the menu and click on Patrol Settings:
1. Press Start Setting.
2. Select patrol no. 1.
3. At Add KeyPoint, select a KeyPoint and assign a
preset to it.
4. Set the duration and speed.
•
Patrol Preset: Sequence
•
Duration: Time that the PTZ camera waits at a posi-
tion (in seconds)
•
Speed: Start-up speed
5. Accept the settings by pressing Confirm.
6. Exit the settings by pressing OK.
Note
A patrol consists of at least two preset positions.
You can set several patrols for one camera.
The set patrol can be tested as follows:
Click on StartSeq and monitor the patrol.
You can stop the patrol at any time by pressing
EndSeq and repeat the patrol settings (e.g. to
make corrections).
21
