9
Learning
1. Set the Secvest wireless control unit into learning mode. Consult the instructions of the control unit for more details.
2. Activate one of the two tamper contacts of the external wireless siren to send a tamper message to the wireless
alarm system.
3. Make sure that the siren is recognised by your wireless control unit, then close the housing. In doing this, ensure
that the spring of the tamper contact sits correctly.
Settings on the control unit
The external wireless siren can acknowledge the set and unset of the alarm centre using the flashing LED bar or piezo.
Consult the relevant chapter of the Secvest 2WAY, Secvest-IP or Terxon 2WAY Module installation manual for more
details.
Maintenance
The flashing bar and siren should be checked on a regular basis. Both tamper contacts should be checked during
maintenance. Check whether water or insects have entered through the housing. If necessary, clean the equipment
accordingly and carry out preventative measures to stop future infiltration.
The batteries should be replaced every two years, or when a corresponding message is shown on the Secvest display.
ABUS Security-Center GmbH & Co. KG, hereby declares that the device with item number FUSG50000 complies with
the essential requirements and other relevant provisions of Directive 1999/5/EG. The declaration of conformity can
be obtained from the following address:
ABUS Security-Center GmbH & Co. KG
Linker Kreuthweg 5
86444 Affing
GERMANY"
