15
d) Binding function
Thus, the transmitter and receiver can communicate with
each other, you need through the same digital code are
bound together. When delivered, the transmitter and
receiver already matched and can be used immediately.
The renewal of the binding function is primarily required
for a transmitter or receiver changes or to correct faults.
If a new connection between the transmitter and receiver
may be necessary, please proceed as follows:
Unplug all servos from the receiver. Turn on the
transmitter. Then open the main menu and select the
submenu "RX setup". Now select the function
"Bind with a receiver". Connect a battery to the receiver
and the corresponding BIND cable insert at (B / VCC). The LED on the receiver will flash briefly.
The transmitter ends the binding function when a secure connection has been established. Now unplug the battery
from the receiver and plug in the servos. After that make a restart to make sure that every servos works well.
12. Install telemetry module
a) Install a speed telemetry module
The receiver allows you to connect a speed sensor
on the model. For this purpose you need to draw a line on
the rotating part with a permanent marker. If a white
rim is installed, you have to draw a black line.
The distance between the line (3) and the sensor (2) may
not be larger than 2 mm. The line (3) must be parallel to the
sensor (2). The line must have the width of the sensor.
Once you have turned on the transmitter and receiver, the
message "engine speed RPM 2:0" is on the LCD screen.
Then open the main menu and select the submenu
.
"
e
c
n
a
ts
id
d
n
a
d
e
e
p
S
"
n
oi
tc
n
u
f
e
h
t
tc
el
e
s
w
o
N
.
"
p
u
t
e
s
X
R
"
Set this to the circumference of the tire, so that the
speed sensor is working properly.
b)
Install a voltage telemetry module
Connect the red and the black connector directly to the battery, or the battery balancer.
The red wire is positive and the black wire is negative. If you have connected the connector correctly, the display will show
"Ext voltage2 ": and the voltage.
c) Install a temperature telemetry module
Connect the temperature sensor to a component which can be warm. The display will show "Temperature 2"
and the respective temperature.
To connect the respective sensors you need the included black / white / red wire in the plug "IN" input on the receiver
and plug the sensors in the "OUT" output. To connect more than one telemetry module, simply plug the cable continuously
in the respective inputs of the sensors.
Picture 6
Picture 7
