14
Require in addition to the steering servo on receiver output "CH1" and the throttle servo/speed controller receiver output
"CH2" can be connected additional a servo to receiver output "CH3". This servo takes at the push of a button functions
on the transmitter.
In an electric model with mechanical speed controller is for the power supply of the receiver a battery box or
a separate receiver battery required. The power connector which is mounted on the mechanical speed controller must not
be used because the voltage at the plug from 7.2 V (at 6 cell battery) is too high for the receiver and the servos.
In an electric model with electronic speed controller is a separate receiver battery for port „B/VCC“ required if the used
motor controller has no BEC-circuit. For more information, please refer to the technical documentation of the controller.
b) Install the receiver
Installation of the receiver is always dependent on the model. Therefore, you should follow with respect to the
incorporation of the recommendations of the manufacturer's model.
In general, you should always try to position the receiver so that it is optimally protected from dust, dirt, moisture
and vibration. Suitable for mounting double-sided adhesive foam or rubber rings that hold the receiver in foam
wrapped securely in place.
Drove the antenna wire directly out of the model.
The antenna wire of the receiver has a precisely measured length. For this reason, the antenna
wire do not wound, laid in loops or cut. The range of the transmitter would be severely limited and
has been pose a significant security risk.
c) Install the servo
The installation of a servo is always dependent on the used model. Detailed information is given in the manual
of the model.
Of hard to process rowing servos and linkages can not run into the required position. They consume electricity
unnecessarily, and the model has an unclean control behavior.
Mount the servo arm always at a 90 ° angle to the steerin linkage. In an angel to the pushrod standing servo arm
are not both control directions must be equal.
Make sure before installing the servo arm for the drive and steering function that the trim function of
the respective channel is in the center position. For more information, see the section "Setting and check
the digital trims" manual.
The servo arm to channel 3 (CH3) must be mounted so that it can run when switching from one end to
the other ..
