Absco Industries
Assembly Instruction Manual
ABSCO GARAGE
MODEL: RG37601N2
3.7m W x 6.0m D x 3.2m H
Model: RG37601N2
31/08/20
21
Wall Sheeting
Vertical Positioning
• Position each sheet flush with the top of the roof
purlin so that the bottom end overlaps the concrete
slab by 30mm to form a weather-tight seal.
Horizontal Position
• A typical sheet overall width is 773mm.
• When multiple sheets are installed with the typical
one rib overlap the sheet-to-sheet coverage is
740mm.
• The wall length of this garage is 5920mm and it is
made up of eight sheets
8 x 740mm = 5920mm
• This dimension is also the frame and slab size.
• As the coverage-to-coverage of a sheet and it’s
actual width are different the sheets on either end
of the wall will extend past the framing by 16.5mm.
This is used to fix into the other corner sheet neatly.
• Using a stringline and spirit level to identify and fix
misalignments as you go.
• Fix through every second pan into the top and
bottom girts, outermost purlin and frame uprights
where possible.
• The coverage of each sheet can vary slightly so it is
important to keep checking as you go.
• As stated previously the last sheet in the wall must
overhang by 16.5mm. You can stretch or shrink
the sheeting coverage as you lay each sheet to
accomplish this.
• The short angled front wall sheets are to have
their straight edge aligned with underside of the
header beams.
• The narrower side sheets for the front wall (237-1)
have a raw edge, position as shown.
• The narrower side sheets for the front wall (237-1)
are to be placed before/behind the shorter angle
sheets. Align the top edge of this sheet with the
topside of the header beam, this will make a 30mm
overhang of the slab edge.
Optional Personal Access Door Location
• Refer to PA Door instruction manual PADRG for
further instruction.
16.5
16.5
237-1
286
079R
079L
066R
066L
085P
312L
299L
299R
286
Front left view
Orientate raw edge to
inside
8 sheets
per wall
8 sheets
per wall
Back right view
312R
318P
