background image

1300 663 868 | [email protected] | aussietraveller.com.au

BRISBANE SHOWROOM:

 11-15 Oasis Court, Clontarf QLD 4019 | 

MELBOURNE SHOWROOM: 

235 Barry Road, Campbellfield VIC 3061

COOLABAH AWNING AND ANNEXE WALLS

SETTING UP THE AWNING

1.  While holding the outrigger bar with one hand, 

reach up with the other and release the Quick 
Release under the container, holding the outrigger, 
arms etc. The blind rod cover will lift out of the way 
automatically. 

2.  Lower the outrigger and arms gently to the ground 

(avoiding lights on van wall) and extend out until 
arms are straight.  

3.  To straighten arms completely, lift out from down 

near the outrigger - this prevents any strain on the 
hinges. 

4.  Depress the spring button on the arms and slide 

pipe sleeve over the arm hinge, making sure 
the sleeve passes the spring button to hold it in 
position.  

5.  Once the arms are braced wires will automatically 

tension and outside ropes no longer needed. 

6.  Release the brake on the roller and pull the canvas 

roof out as far as the outrigger. 

7.  Unclip the legs and lift the outrigger up, then lower 

the front legs into place. Leave legs in lowered 
position. 

8.  Slide blind rod in behind the legs, one side at a 

time, and clip into place. Adjust the legs up to the 
required height. 

9.  Fit the winder handle to the shaft on the roller 

and winding in a clockwise direction, tension the 
awning roof back into the container and lock into 
place. 

10.  Secure the touch-tape on the outside of the roof 

canvas and onto the arms to prevent the sides of 
the roof from flapping. 

11.  Peg the legs down securely. In the event of rain it 

may be necessary to lower one or both of the front 
legs to assist with water runoff. 

12.  Fit the Curved Roof Rafters above the wire 

bracing, as shown in image.

Reviews: