Absco Industries
Assembly Instruction Manual
ABSCO GARAGE
MODEL: RG37601N2
3.7m W x 6.0m D x 3.2m H
Model: RG37601N2
31/08/20
16
Frame Construction
3. Internal Frames
• Secure the first internal frame to the slab
• Fit the four side wall girts (K1933) to the same
height as the rear wall girts.
• Bend the inside tab of the K1933’s to a right angle
so it can be fixed into the rear wall girt. See detail.
• To stabilise the structure secure two wall sheets
as shown. Make sure that each wall sheet (286)
overhangs the slab by 30mm and is 80mm past the
top of the uprights.
• Fixings used for wall sheeting are hex head tek
screws without neoprene washers (FAST035).
Positioned in-line with the girts at every second
sheet pan.
• The wall sheeting should poke out past the
back frame 16.5mm to connect into the rear wall
sheeting later. See page 21 for greater detail.
• Use a spirit level to check that the framing is 100%
vertical. Use a tape to measure and check that the
diagonal dimensions across the framework are
equal.
