Absco Industries
Assembly Instruction Manual
ABSCO SKILLION CARPORT
MODEL: CPDN2
5.50mW x 5.50mD x 2.37mH
Model: CPSN2
25/11/22
15
DOWNPIPE
It can be fit to either end of the rear beam, make
a decision based on site specific factors.
Cut a round hole 51mm dia in one end of the
rear edge beam. The can be done by drilling a
series of 3mm holes and knocking it out or by
metal holesaw. It won’t be visible when finished.
Fit the galvanised gutter drop RWG17 from the
top down into the hole.
Drill two 3 mm holes through the underside of
the end beam and into the flange of the gutter
drop and then fasten using two pop rivets. Use
water proof sealant around the hole inside the
beam.
Join the top three pieces of the down pipe
assembly, RWG02 + RWG13 + RWG02 with PVC
solvent welding cement. Position over the gutter
drop and align with post.
Drill two 3 mm holes through both sides of the
PVC elbow and into the gutter drop and then
fasten with two tek screws.
Fit one end of downpipe RWG14 with the elbow
RWG01 at trim the other end to the desired
height. Fix with PVC solvent welding cement.
Bend two 270 x 25 mm flat strips ZACO126 to
shape around the downpipe and to the sides of
the post and fasten with tek screws.
Immediate maintenance required!
Clean down all roof and beam internal areas
of metal filings from drilling operations and
self drilling screws.
If not cleaned these will cause discolouration
and corrosion to roof sheets and galvanised
framing sections, see warranty for more details
RWG01
RWG02
RWG02
RWG14
1880 mm
ZACO126
RWG13
1200 mm
ZACO126
RWG17
RWG02
SIDE
BEAM
REAR
BEAM
Inset from
side beam
110 mm
110
