7
Installation, Operating and Maintenance Instructions (Original Instructions)
ABS submersible sewage pump XFP 80C - 201G
5
Transport and Storage
5.1
Transport
During transport, care should be taken that the pump is not dropped or thrown.
The pumps of the XFP series are fi tted with a lifting hoop to which a chain and shackle may be attached for
transport or for suspension of the pump.
The pump must be raised only by the lifting hoop and never by the power cable.
Take note of the weight of the entire unit. The hoist and chain must be adequately dimensioned for
that weight and must comply with the current valid safety regulations.
All relevant safety regulations as well as general good technical practice must be complied with.
5.2 Storage
During long periods of storage the pump should be protected from moisture and extremes of cold or heat.
To prevent the mechanical seals from sticking it is recommended that occasionally the impeller is rotated by
hand.
If the pump is being taken out of service the oil should be changed before storage.
After storage the pump should be inspected for damage, the oil level should be checked, and the impeller
checked to ensure it rotates freely.
5.2.1 Moisture protection of motor connection cable
The motor connection cables are protected against the ingress of moisture along the cable by having the ends
sealed at the factory with protective covers.
ATTENTION!
The ends of the cables should never be immersed in water as the protective covers
only provide protection against water spray or similar (IP44) and are not a water tight
seal. The covers should only be removed immediately prior to connecting the pumps
electrically.
During storage or installation, prior to the laying and connection of the power cable, particular attention should
be given to the prevention of water damage in locations which could fl ood.
ATTENTION!
If there is a possibility of water ingress then the cable should be secured so that the
end is above the maximum possible fl ood level. Take care not to damage the cable or
its insulation when doing this.
1.
2.
3.
4.