Ultima OPIR-5 Detector
9
3.3 System Mounting
The Ultima OPIR-5 Detectors are shipped with either mounting assembly shown in Figure 4.
After the mounting location has been established, mount the support arm/base. Attach a pan-
tilt assembly to each unit. Apply lithium grease on each taper joint before attaching a unit to a
support arm/base. Add the supplied bolt and washers; do not tighten until unit is fully
adjusted. If the bolt has been tightened and further adjustment is necessary, loosen the bolt
two turns and use a screwdriver between the pan-tilt assembly and arm to release the taper.
Figure 4: Outline and Dimensional Drawing
Pan Tilt Arm Assembly with Fine Adjustments
Basic Arm Assembly
Pan Tilt Base Assembly with Fine Adjustments
