Ultima OPIR-5 Detector
vi
Quick Start Guide
System Mounting
The Ultima OPIR-5 Detectors are shipped with either mounting assembly shown below. After
the mounting location has been established, mount the support arm/base. Attach a pan-tilt
assembly to each unit. Apply lithium grease on each taper joint before attaching a unit to a
support arm/base. Add the supplied bolt and washers; do not tighten until unit is fully
adjusted. If the bolt has been tightened and further adjustment is necessary, loosen the bolt
two turns and use a screwdriver between the pan-tilt assembly and arm to release the taper.
Pan Tilt Arm Assembly with Fine Adjustments
Support Arm Assembly
Pan Tilt Base Assembly with Fine Adjustments
