Abit KG7, User Manual

Page: 69 / 104

RAID Setting Guide 4-5
User’s Manual
"
Select Source Disk:
This item is to select the source disk. The size of source disk must be smaller or equal to the target
disk.
"
Select Target Disk:
This item is to select the target disk. The size of target disk must be greater or equal to the one of
source disk.
"
Start Duplicating Process:
After you had selected this item, the BIOS setting will take up to 30 minutes to run the duplication.
Please wait or you may press <Esc> to cancel.
4-3-4. OPTION 4: Add Spare Disk
These are the steps to add the spare disk.
1. In the menu zone, select “
4. Add Spare Disk
” and press <Enter> to confirm.
2. In menu zone of the pop up subinterface, select “
1. Select Mirror Array: None
” and press <Enter>
to confirm.
3. In the validated channel status zone, select the mirror array and press <Enter> to confirm.
4. In the menu zone of the pop up subinterface, select “
2. Select Spare Drive: None
” and press <Enter>
to confirm.
5. In the validated channel status zone, select the spare disk to be added and press <Enter> to confirm.
4-3-5. OPTION 5: Remove Spare Disk
These are the steps to remove the spare disk.
1. In the menu zone, select “
5. Remove Spare Disk
” and press <Enter> to confirm.
2. The “
1. Select Mirror Array: None
” item appears in the menu zone of pop up subinterface.
3. In the validated channel status zone, select the spare disk to be removed and press <Enter> to confirm.
4-3-6. OPTION 6: Set Disk Mode
This item allows you to select the drive transfer mode for the hard disk(s).
Use the up/down arrow to select the menu option to “ Set Disk Mode ” and press <Enter>. In the Channel
Status, select the channel you would like to set and press <Enter>, there will comes out an asterisk mark
in the parentheses indicating that the channel selection had be done. Choose the mode from the pop-up
menu. You can choose from PIO 0 ~ 4, MW DMA 0 ~ 2, and UDMA 0 ~ 5.