Abit KG7, User Manual

Page: 38 / 104

Chapter 3
KG7-Lite/KG7/KG7-RAID
3-10
Figure 3-4B. Advanced BIOS Features Setup Lower Screen
Virus Warning:
This item can be set to Enabled or Disabled, the default setting being Disabled .
When this feature is enabled, if there is any attempt from a software or an application to access the boot
sector or the partition table, the BIOS will warn you that a boot virus is attempting to access the hard disk.
Quick Power On Self Test:
After the computer has been powered on, the BIOS of the motherboard will run a series of tests in order
to check the system and its peripherals. If the Quick Power on Self-Test feature is enable, the BIOS will
simplify the test procedures in order to speed up the boot process. The default setting is
Enabled .
First Boot Device:
When the computer boots up, the BIOS attempts to load the operating system from the devices in the
sequence selected in these items: floppy disk drive A, LS120, ZIP100 devices, hard drive C, SCSI hard
disk drive or CD-ROM. There are ten options for the boot sequence that you can choose (The default
setting is
Floppy .):
Floppy
)
LS120
)
HDD-0
)
SCSI
)
CDROM
)
HDD-1
)
HDD-2
)
HDD-3
)
ZIP100
)
LAN
)
Back to Floppy.
(KG7-Lite/KG7 Only)
Floppy
)
LS120
)
HDD-0
)
SCSI
)
CDROM
)
HDD-1
)
HDD-2
)
HDD-3
)
ZIP100
)
LAN
)
ATA100RAID
)
Back to Floppy. (KG7-RAID Only)
Second Boot Device:
Description is the same as the First Boot Device, the default setting is HDD-0 .
Third Boot Device:
Description is same as the First Boot Device, the default setting is LS120.
Boot Other Device:
Two options are available: Enabled or Disabled. The default setting is Enabled . This setting allows the
BIOS to try to boot devices other than the three which are listed in the above First, Second and Third
Boot Devices. If you set to Disabled, the BIOS will boot from only the three kinds of boot devices that
are set above.