Abit BH6, User Manual

Page: 46 / 98

3-26 Chapter 3
Resume by LAN:
To enable this feature, you must make sure your network software and
network adapter (LAN card) support such a function. This function is also
called “ Wake on LAN “ (WOL).
Power on by Ring:
If you connect an external modem to the onboard serial port, the system
will be turned on when a telephone ring-up occurs.
Power on by Alarm:
RTC alarm can turn on the system. You can set date ( of month ) and time
( hour , minute , second ).
PM Timer Events:
When one of the specific occurs, the count down made for entry in power
saving mode goes back to zero.
Since the computer will enter a power saving mode only after an inactivity
delay specified (time specific for Doze, Standby and Suspend modes) and
after it has no activity, during this time period, any event will cause the
computer to re-count the time elapsed. Resume events are operations or
signals that cause the computer to resume time counting.
"
IRQ [3-7, 9-15], NMI:
If any IRQ or NMI (Non-Mask Interrupt) activities occur, this will cause
the computer to re-count the time elapsed.
"
VGA Active Monitor:
If there is any VGA data transfer or any I/O activities, this will cause the
computer to re-count the time elapsed.
"
IRQ8 Break Suspend:
Supports the RTC alarm wake up from suspend function (via IRQ8).
"
IDE Primary Master:
If any IDE primary master I/O activity occurs, it will cause the computer
to re-count the time elapsed.
"
IDE Primary Slave:
If any IDE primary slave I/O activity occurs, it will cause the computer
to re-count the time elapsed.
"
IDE Secondary Master:
If any IDE secondary master I/O activity occurs, it will cause the
computer to re-count the time elapsed.