EN
-
26
BAL.0716.0 • 2022-01-11
8 Putting out of operation
ABIPLAS
®
CUT HF
7.7 Cutting process
8 Putting out of operation
1
Switch off the power source.
2
Close the compressed air feed.
WARNING
Arc eye
The arc produced can damage the eyes.
• Check and wear your personal protective equipment.
NOTICE
• All necessary parameters (such as the cutting current, soft start, compressed air etc.) must
be set on the power source in accordance with the cutting operation.
• Information and tips on the direct cutting process (technique, procedure, materials,
plasma...) can be found in the relevant technical literature and not in these operating
instructions.
• Only qualified personnel are permitted to perform work on the device or system.
• Consult the documentation for the welding components.
• Check the actual gas flow on the measuring instruments or by closing and opening the
corresponding gas outlet openings on the torch.
NOTICE
• When decommissioning the system, ensure that the procedures for switching off the
welding components are observed.
