13
3.4
Locking the Buttons (C):
Press and hold button C for more than 6 seconds to lock or unlock the buttons, LOC is
displayed and indicated that the buttons are locked. Once it’s locked LOC will be flashing for
6 seconds then disappear, press any button LOC will flash again. Long press button C for 6
seconds to unlock the buttons. Please note the button B(ON/OFF) is never locked.
3.5
Heating ON/OFF:
Heating Mode Quick Start:
Press button E or F to quick start heat setting as following:
a. Press either button E or F to view the current temperature on the display.
b. Press button E or F to set the desired room temperature. Press button C to confirm the
desired setting. If the desired heating temperature is higher than the room temperature,
the unit starts heating. If the desired heating temperature is lower than the room
temperature, the unit will not heat. The heating temperature ranges from 10°C to 30°C.
3.6
Setting the temperature:
High Heating:
At default interface, press button D (three lines) to display letter H and flashing heating icon
as following:
Press OK button to set temperature. The default temperature is 10°C(50°F). It’s displayed
as following:
Press button E or F to adjust temperature. If the set temperature is higher than the room temperature detected by
appliance, the heating starts. The heating will not start if the set temperature is lower than the room temperature.
Low Heating:
At default interface, press button D twice to display letter L and flashing heating icon as
following:
Press OK button to set temperature. The default temperature is 10°C(50°F). It’s displayed
as following:
If the set temperature is higher than the room temperature detected by appliance, the heating starts. The heating
will not start if the set temperature is lower than the room temperature.
3.7
Celcius/Fahrenheit Setting:
The default temperature readout is Celcius. Long press button D for 3 seconds then press button E or F to change
the temperature readout from Celcius to Fahrenheit.
3.8
Brightness Control:
Brightness Control is to select the desired flame brightness level. At default
interface, keep pressing button D to select the Brightness Control, it’s
displayed “bri” and flashing light bulb icon as following:
Press button C to start the brightness setting. Press button E or F to select
the brightness level.
5 brightness levels are selectable. Default setting is 3.
5 is the highest level as shown following: