22
User’s guide VUBB
|
1ZSC000562-AAL en
Fig. 39. Check that the shaft cannot be moved more than 2 mm in the axial
direction.
Fig. 40. Push the two protective tubes horizontally.
Fig. 41. Clamp two hose clips.
Fig. 42. Self-adhesive information plates on the tubes.
14. Tighten the outer two screws; see Fig. 34. Tightening
torque 10 Nm ±10 %.
15. Tighten the remaining screws crosswise (see Fig. 35) with
the same tightening torque.
16. Push the two protective tubes horizontally until they touch
the bevel gears. See Fig. 40.
Make sure that the slot on the protective tubes is
facing downwards.
17. Clamp the protective tubes with the hose clips. See
Fig. 41.
18. Apply the self-adhesive information plates around the
tubes at about the middle of the tube length. See Fig. 42.
2 mm
12. Fit six screws and washers in the holes on the coupling
halves (see Fig. 33) and lightly tighten them.
13. Check that the axial play is no more than 2 mm. See Fig.
39. If necessary, adjust the axial play by operating the
couplings on the shaft end.
