ABB TZIDC-110, Operating Instructions Manual

Page: 25 / 59

41/18-77 EN Electro-pneumatic positioner TZIDC-110 25
3.4 Commissioning
3.4.1 Procedure
1. Turn on the air supply to the positioner.
2. Connect the bus with arbitrary polarity (or auxiliary power 9 V DC ... 32 V DC)
to the bus terminals.
is displayed.
3. Check for proper mounting:
- Press and hold
M
ODE
and
E
NTER
simultaneously. Wait until the countdown
has run down from 3 to 0, then release
M
ODE
and
E
NTER
.
The operating
level (mode 1.x) is reached and indicated.
- Press and hold
MODE
.
- Additionally briefly press or until mode 1.3 (manual adjustment within the
sensor range) is displayed.
- Release
MODE
.
- Press or to move the actuator to its mechanical limit stops in both directions,
and note the values. The angle of rotation is indicated in degrees.
4. Return to the remote level.
- Press and hold
MODE
and
ENTER
.
- Wait until the countdown has run down from 3 to 0, then release
MODE
and
ENTER
.
is displayed.
IMPORTANT
The positioner should be mounted/adjusted in such a way that the porti-
ons of the sensor’s operating range above and below the center point are
nearly identical. Make sure to use the rotation angle of the position sen-
sor in the positioner to its utmost extent. Refer to
chapter 3.1 "Mechani-
cal mounting"
for details about how to readjust/correct if required.
conf
mA
%
C °
Recommended range:
between -28° and +28° for linear actuators
between -57° and +57° for rotary actuators
Minimum angle: 25°
conf
mA
%
C °