A
B
C
D
IEC15000446-2-en.vsdx
IEC15000446 V2 EN-US
Figure 2:
Different mounting methods
Description
A
Flush mounting
B
19” Panel rack mounting
C
Wall mounting
D
Side-by-side rack mounting
5.3.1
Flush mounting
IP10303-1 v1
5.3.1.1
Overview
M11967-3 v5
The flush mounting kit can be used for the 1/2 x 19” case size.
Only a single case can be mounted in each cut-out on the cubicle panel, for class IP54
protection. The screws from the IED shall be used to fasten the fasteners to the IED.
Flush mounting cannot be used for side-by-side mounted IEDs when IP54 class
must be fulfilled. Only IP20 class can be obtained when mounting two cases
side-by-side in one (1) cut-out.
To obtain IP54 class protection, an additional factory mounted sealing must be
ordered when ordering the IED.
Section 5
1MRK 514 027-UEN D
Mounting
20
650 series
Installation manual
© Copyright 2017 ABB. All rights reserved