1. If needed, set the IP address for the IEDs.
2. Set up the PC or workstation for a direct link (point-to-point), or
3. Connect the PC or workstation to the LAN/WAN network.
4. Configure the IED IP addresses in the PCM600 project for each IED to match the
IP addresses of the physical IEDs.
Setting up IP addresses
The IP address and the corresponding mask can be set via the LHMI for each available
Ethernet interface in the IED. Each Ethernet interface has a default factory IP address
when the complete IED is delivered.
•
The default IP address for the IED front port is 192.168.0.254 and the
corresponding subnetwork mask is 255.255.255.0, which can be set via the local
HMI path
Main menu/Configuration/Communication/TCP-IP
configuration/Front port
.
•
The default IP address for the IED rear port is 192.168.2.10 and the corresponding
subnetwork mask is 255.255.255.0, which can be set via the local HMI path
Main
menu/Configuration/Communication/TCP-IP configuration/LAN1
.
The front and rear port IP addresses cannot belong to the same subnet
or communication will fail. It is recommended to change the IP
address of the front port if the front and rear port are set to the same
subnet.
Setting up the point-to-point access to IEDs front port
The IED front port is a standard Ethernet interface with DHCP server functionality.
When a PC is connected to the front port, the DHCP server automatically assigns the
IP address from the same subnetwork.
See the operating system manual for details on how to obtain the IP
address automatically.
1. Connect the PC network adapter to the IED front port.
2. Wait until the operating system automatically acquires the
network address.
3. Check that the front port connector green status LED is lit.
4. Ping the IED to verify that the connection is correctly established.
The default IP address of the front port is 192.168.0.254.
Use Ethernet crossover cables only for point-to-point connections.
Modern network adapters contain logic for automatic detection if they
are connected directly to another network adapter using a regular
Ethernet cable.
1MRS756800 F
Section 4
Setting up a project
630 series
27
Engineering Manual