Chapter 7
Settings and configuration
7:2.7.2 Reset All Settings
To reset all the changed parameters back to factory default settings, enter this menu.
Confirmation of reset will be displayed as
Done
on the LCD. The supply voltage should
also be disconnected and reconnected.
The real time clock, the hour run meter, the number of starts and the presentation lan-
guage will not be affected by the reset.
!
Caution!
The motor may start unexpectedly if there is a start signal present when doing any
of the actions listed below.
• Switching from one type of control to another (fieldbus control / hardwire control)
• Re-programming the programmable inputs
• Reset all Settings (programmable input set to Enable)
7:2.7.3 Operation (test) mode
The Operation mode makes it possible to switch between two different modes in the
softstarter: a demo mode and the regular operation mode. By entering the demo mode,
programmable inputs/outputs, start and stop circuits, by-pass contactor etc. can be
tested before the unit is put into operation. As long as the unit is in demo mode, the color
on the display is inverted (except on the external keypad).
!
Caution!
Never enter the demo mode with the main voltage connected. The by-pass contactor will
close at TOR and may start the motor.
Information!
The total run time of the motor and the total number of starts will be counted also
during demo mode. When exiting demo mode, these values will be reset to previous
values. Parameters changed and the Event Log will be kept when exiting demo mode.
Figure 36: Reset all Settings menu
Top level
Settings
Application setting
Basic settings
Functional settings
Presentation settings
Service settings
All settings
Changed settings
Reset all settings
Operation mode
Figure 37: Reset all Settings menu
Top level
Settings
Application setting
Basic settings
Functional settings
Presentation settings
Service settings
All settings
Changed settings
Reset all settings
Operation mode
Figure 38: Display appearance in normal mode
Operation Mode
Select
Back
Figure 39: Display appearance in demo mode
Operation Mode
Select
Back
7.22
Low Voltage Products & Systems
1SXU 132 021 M0201
ABB nc. • 888-385-1221 • www.abb-control.com
7
