7.2.4 Problem releasing the robot brakes
Description
When starting robot operation or jogging the robot, the internal robot brakes must
release in order to allow movement.
Required test equipment
Equipment needed for troubleshooting:
Note
Equipment
Multimeter
Insulating gloves
3HAC074000-008
Circuit diagram - OmniCore V250XT
, rev 04
or later
Preparations
Action
Make sure that the controller is switched on.
1
Wait 30 s - 1 min to enable start-up sequence.
Check the FlexPendant for errors and warnings.
2
DANGER
Troubleshooting on the controller while powered on must be performed by personnel
trained by ABB or by ABB field engineers.
Recommended working procedure
If the brakes do not release, no robot movement is possible and a number of error
log messages can occur. Use this procedure to troubleshoot what might cause the
problem.
Look at the following block diagram to understand how power is connected from
incoming and forward.
Block diagram
T
Motor connector
X1
Manipulator
Power unit
A1
24V_BRAKE_PWR
24V_BRAKE_REL
Floor cable
X11
X13
X15
Main drive unit
T4
xx2100001141
Continues on next page
Product manual - OmniCore V250XT Type B
355
3HAC087112-001 Revision: A
© Copyright 2023-2023 ABB. All rights reserved.
7 Troubleshooting
7.2.4 Problem releasing the robot brakes
Summary of Contents for OmniCore V250XT Type B
