CHARGING STATION
STATUS
Released
DOCUMENT ID.
TBA
REV.
A
LANG.
EN
PAGE
15/37
© Copyright 2019 ABB. All rights reserved.
3.
Configuration
This chapter describes the necessary configuration for the correct operation of the charging stations.
The following steps are necessary for this:
•
Set the DIP switch on the charging station
•
Configuration (via the web interface or via USB stick)
Depending on the network configuration, activation of the DHCP server on the master charging station
may be necessary.
3.1.
Connection panel
In the connection panel of the charging station are important interfaces and controls for the
configuration of the charging station. To access, the housing cover and the connection panel cover must
be removed. The description of removing the covers and the connection panel can be found in the
"Installation Manual".
3.2.
DIP switch settings
This DIP switch setting must be made for each master and slave charging station to enable charging
station communication.
Caution!
Possible damage to the DIP switches!
The DIP switches are rocker switches and not slider switches. The DIP switches
must be pressed and must never be slid.
ON/OFF position of the rocker switches
The illustration shows the position of the rocker switches for the setting ON and OFF