L2234
Emax
110/158
Model
Scale
Page No.
Doc. No.
Apparatus
1SDH000460R0002
L2778
14.6.4
Error messages displayed in pop-up windows
All the messages that appear on the display in a pop-up window are described below.
Error message
Description
Notes
L2 Sensor
Alarm for L2 phase current sensor
Phase L2 sensor disconnected or faulty
L3 Sensor
Alarm for L3 phase current sensor
Phase L3 sensor disconnected or faulty
Ne Sensor
Alarm for Ne phase current sensor
Phase Ne sensor disconnected or faulty
Gext Sensor
Alarm for Gext current sensor
Gext sensor disconnected or faulty
TC disconnected
Trip Coil disconnected or faulty
Rating Plug
Rating Plug Error absent or faulty
Power factor
Power factor error
The power factor module is lower than the specified threshold
Phase cycle
Phase cycle inverted
Invalid date
Clock information lost
CB status
CB status error
Probable error in Q26 and/or Q27
Installation
Key plug error
CB not defined
State of circuit-breaker inconsistent (Open/Closed)
Probable error in Q26 and/or Q27
Local Bus
Local Bus error
See par. 14.7
Contact wear
Contact wear prealarm
Contact wear
≥
80%
L prealarm
Protection L prealarm
T prealarm
Protection T prealarm
Frequency range
Frequency out of range
Warning Iw
Iw threshold exceeded
Timing L
Timing protection L
Timing S
Timing protection S
Timing S2
Timing protection S2
Timing G
Timing protection G
Timing Gext
Timing protection Gext
Timing D
Timing protection D
Timing U
Timing protection U
Timing UV
Timing protection UV
Timing OV
Timing protection OV
Timing RV
Timing protection RV
Timing RP
Timing protection RP
Timing UF
Timing protection UF
Timing OF
Timing protection OF
Error message
Description
Password error
Session impossible
A programming session cannot be started due to a contingency (e.g. a timer-controlled delay still elapsing)
Value outside range
Value beyond the established limits
Failed 1001/2001
Incongruence between thresholds of protections L and S (SET1/SET2)
Failed 1002/2002
Incongruence between thresholds of protections I and S (SET1/SET2)
Failed 1006/2006
Incongruence between thresholds of protections I and D (SET1/SET2)
Failed 1005/2005
Incongruence between thresholds of protections L and D (SET1/SET2)
Failed 1009/2009
Zone selectivity enabled in both protection D and S or S2
Failed 1003/2003
Incongruence between thresholds of protections L and S2 (SET1/SET2)
Failed 1004/2004
Incongruence between thresholds of protections I and S2 (SET1/SET2)
Failed 3001
Inconsistency as to language change
Failed 3002
Inconsistency on Rc toroid
Failed 3003
Inconsistency as to external Neutral configuration
Exception 6
Control temporarily unavailable
Unavailable
Function temporarily unavailable