CAP 505
ABB Automation
3
User’s Guide
2. Using the Protocol Edit-
ing Tool
2
2.
Using the Protocol Editing Tool
2.1.
General
This chapter describes the different menus and functions in the Protocol Editing
Tool and how to use these.
2.2.
Protocol configurations
There are three kinds of protocol configurations. These configurations are stored in
three different places:
• “Work configuration”, which is stored in the \POD directory under the object
home directory, e.g. in ..\OBJ0001\POD.
• “User templates”, which are stored in the \POD directory under the project
directory OBJ000\Misc\. This is a common place where the users should save
custom configurations.
• “Standard templates”, which are included in the object type configurations and
they are distributed with the SM/RED package. Users cannot save the custom
POD configuration to these locations.
2.3.
Starting the Protocol Editing Tool
The Protocol Editing Tool is started from the Project Navigator in CAP 505 (see
Figure 2.3.-1).
)LJ 6WDUWLQJWKH3URWRFRO(GLWLQJ7RRO
If a work configuration is found in the project folder, this is opened automatically at
start-up.
1MRS751982-MUM
Protocol Editing Tool
