As the public IP address of ARM600 is case dependent, it is not
possible to define an example. If ARM600 is located in DMZ,
the eth0 IP address can be a private IP address. In that case the
specific ports are forwarded to ARM600 by border router.
Table 11:
Eth0 settings
Parameter
Value
Device
eth0
BOOTPROTO
none
IPADDR
<IP address>
NETMASK
1)
<netmask>
PREFIX
1)
<prefix>
GATEWAY
<gateway IP>
DNS1, DNS2
Set the DNS servers, if needed.
DEFROUTE
Yes
IPV6_DEFROUTE
Yes
1) Set either the netmask or the prefix
The default route is usually set pointing the router in ARM600’s
eth0 subnet. The Arctic devices usually connect from unknown
(dynamic) IP addresses via the eth0 interface, which is by
default the WAN interface in ARM600.
9.
Click
Save
.
10. Click
Restart interface eth0
.
The IP address of the eth0 interface used for the current
connection to ARM600 has now been changed. After the
changes to the eth0 IP address have been applied the browser
will not be able to connect to ARM600 using the address https://
10.10.10.10:10000.
11. Switch the Ethernet cable from ARM600’s WAN interface to the LAN interface.
•
In the standard edition, switch the Ethernet cable to the Gb2 interface.
•
In the Enterprise edition, switch the Ethernet cable to port 2.
If the eth1 interface has been configured according to this example,
use the address https://192.168.0.1:10000 to access ARM600 via its
eth1 (LAN) port. Remember to change the PC’s IP address
accordingly. For example, use the IP address 192.168.0.2 in the PC
with netmask 255.255.255.0.
Section 6
1MRS758861 A
Network configuration
28
ARM600
User Manual
