Section 6
Network configuration
6.1
Configuring Ethernet interfaces
The Ethernet interfaces are configured using the WHMI.
1.
Connect the PC to ARM600's eth0 port.
2.
Log in to the ARM600 WHMI.
3.
In the left pane, under
Network
, click
Network Configuration
.
4.
Click the
Network Interfaces
icon.
The
Network Interfaces
pane opens.
5.
Click
Edit interface eth1
and configure the eth1 parameters.
It is recommended to configure the eth1 interface (LAN) first, as
the PC is now connected to ARM600 via the eth0 interface
(WAN).
Change the IP address and netmask according to the required
setup. Either set the netmask or the prefix (number of bytes in
netmask), not both.
Table 10:
Eth1 settings
Parameter
Value
Device
eth1
BOOTPROTO
none
IPADDR
<IP address>
NETMASK
1)
<netmask>
PREFIX
1)
<prefix>
DEFROUTE
No
IPV6_DEFROUTE
No
1) Set either the netmask or the prefix
6.
Click
Save
.
7.
Click
Restart interface eth1
.
8.
Click
Edit interface eth0
and configure the eth0 parameters based on the
information received from the Internet Service Provider or from the ICT
department.
1MRS758861 A
Section 6
Network configuration
ARM600
27
User Manual
