ABB ACS880-207LC, Hardware Manual

Page: 30 / 120

Cooling system
See chapter Internal cooling circuit .
￭ Coolant connectors
The coolant pipe inlet and outlet connectors are located at the bottom front of the IGBT
supply module. The connectors are for 16/13 millimeter PA (polyamide) pipe.
WARNING!
For a reliable connection, the end of the pipe entering the connector must be
completely intact for a length of at least 5 cm (2 in). Make sure the pipe is perfectly
round where it enters the connector, and not deformed eg. by any bends nearby.
The piping must not exert any tension or torque on the connector.
Type designation label(s)
Each IGBT supply unit has a type designation label attached onto the inside of the cubicle
door. The type designation label includes the ratings, appropriate markings, a type
designation and a serial number of the unit. Example label is shown below.
Quote the complete type designation and serial number when contacting technical support.
1
2
3
4
5
6
Type designation (see section Type designation key (page 31) ).
1
Frame size 2
Short-time withstand current rating (see chapter Technical data ); degree of protection; UL/CSA specific-
ations
3
Ratings. See also chapter Technical data . 4
Valid markings. See Electrical planning instructions for ACS880 liquid-cooled multidrive cabinets and
modules (3AXD50000048634 [English]).
5
Serial number. The first digit of the serial number refers to the manufacturing plant. The next four digits
refer to the unit’s manufacturing year and week, respectively. The remaining digits complete the serial
number so that there are no two units with the same number.
6
30 Operation principle and hardware description