ABB ACS 600 Series, Hardware Manual

Page: 65 / 82

Appendix A – ACS/ACC/ACP 604/607 Technical Data
ACS/ACC/ACP 604/607 Drives ACx=ACS/ACC/ACP A-27
CE Marking
A CE mark is attached to ACx 601/607 drives to verify that the unit follows the
provisions of the European Low Voltage and EMC Directives (Directive 73/23/EEC, as
amended by 93/68/EEC and Directive 89/336/EEC, as amended by 93/68/EEC).
Compliance with the
EMC Directive
EMC stands for Electromagnetic Compatibility. It is the ability of electrical/electronic
equipment to operate without problems within an electromagnetic environment.
Likewise, the equipment must not disturb or interfere with any other product or system
within its locality.
The EMC Directive defines the requirements for immunity and emissions of electrical
equipment used in European Economic Area. The EMC product standard EN 61800-3
covers the requirements stated for drives.
The ACx 607 drives (55 kW to 630 kW) comply with the EMC Directive in industrial low-
voltage network, public low-voltage network (restricted distribution) and IT networks
(ungrounded power lines) with the following provisions:
Industrial Low-Voltage
Network
1. It is ensured that no excessive emission is propagated to neighboring low-voltage
networks. In some cases, the natural suppression in transformers and cables is
sufficient. If in doubt, the ACx 600 can be equipped with EMC filtering (refer to
Table A-1) or the supply transformer with static shielding between the primary and
secondary windings can be used.
2. The ACx 607 is installed with motor and control cables as specified in this manual
(for types ACS/ACC 607-0400-3, -0490-3/5/6, -0610-3/5/6 and -0760-5/6 with
power cables as specified in
ACS 600 Power Extension Range Supplement).
Note: It is recommended to equip the ACx 600 with the EMC filtering if there is
equipment sensitive to conducted emission connected to the same supply transformer
as the ACx 600.