ABB ACH550-01, User Manual

Page: 257 / 454

Parameter listing and descriptions 245
ACH550 User's Manual
Group 32: SUPERVISION
This group defines supervision for up to three signals from
Group 01: OPERATING DATA . Supervision monitors a specified
parameter and energizes a relay output if the parameter passes
a defined limit. Use
Group 14: RELAY OUTPUTS to define the
relay and whether the relay activates when the signal is too low
or too high.
Code Description Range
3201 SUPERV 1 PARAM 101…199
Selects the first supervised parameter.
• Must be a parameter number from Group 01: OPERATING DATA .
• If the supervised parameter passes a limit, a relay output is
energized.
• The supervision limits are defined in this group.
• The relay outputs are defined in Group 14: RELAY OUTPUTS
(definition also specifies which supervision limit is monitored).
LO
≤
HI
Operating data supervision using relay outputs, when LO
≤
HI. See the
figure on page 246 .
• Case A = Parameter 1401
RELAY OUTPUT
1 (or 1402
RELAY OUTPUT
2,
etc.) value is
SUPRV
1
OVER
or
SUPRV
2
OVER
. Use for monitoring when/
if the supervised signal exceeds a given limit. The relay remains
active until the supervised value drops below the low limit.
• Case B = Parameter 1401
RELAY OUTPUT
1 (or 1402
RELAY OUTPUT
2,
etc.) value is
SUPRV
1
UNDER
or
SUPRV
2
UNDER
. Use for monitoring
when/if the supervised signal falls below a given limit. The relay
remains active until the supervised value rises above the high limit.
LO
>
HI
Operating data supervision using relay outputs, when LO>HI. See the
figure on page 246 .
The lowest limit (
HI
3203) is active initially, and remains active until the
supervised parameter goes above the highest limit (
LO
3202), making
that limit the active limit. That limit remains active until the supervised
parameter goes below the lowest limit (
HI
3203), making that limit
active.
• Case A = Parameter 1401
RELAY OUTPUT
1 (or 1402
RELAY OUTPUT
2,
etc.) value is
SUPRV
1
OVER
or
SUPRV
2
OVER
. Initially the relay is de-
energized. It is energized whenever the supervised parameter goes
above the active limit.
• Case B = Parameter 1401
RELAY OUTPUT
1 (or 1402
RELAY OUTPUT
2,
etc.) value is
SUPRV
1
UNDER
or
SUPRV
2
UNDER
. Initially the relay is
energized. It is de-energized whenever the supervised parameter
goes below the active limit.