ABB ACH550-01, User Manual

Page: 177 / 454

Parameter listing and descriptions 165
ACH550 User's Manual
Parameter listing and descriptions
What this chapter contains
This chapter contains the parameter listing of predefined
application macros and descriptions of individual parameters for
the ACH550.
Parameter groups
The parameters are grouped as follows:
•
Group 99: START-UP DATA – Defines the data required to
set up the drive and enter motor information.
• Group 01: OPERATING DATA – Contains the operating data
including actual signals.
• Group 03: FB ACTUAL SIGNALS – Monitors fieldbus
communications.
• Group 04: FAULT HISTORY – Stores a recent fault history
reported by the drive.
• Group 10: START/STOP/DIR – Defines external sources for
commands that enable start, stop and direction changes.
Locks direction or enables direction control.
• Group 11: REFERENCE SELECT – Defines how the drive
selects between command sources.
• Group 12: CONSTANT SPEEDS – Defines a set of constant
speeds.
• Group 13: ANALOGUE INPUTS – Defines the limits and
filtering for analog inputs.
• Group 14: RELAY OUTPUTS – Defines the conditions which
activate relay outputs.
• Group 15: ANALOGUE OUTPUTS – Defines the drive’s
analog outputs.
• Group 16: SYSTEM CONTROLS – Defines system level
locks, Group 17: OVERRIDE – Defines override enabling/
disabling, override activation signal, override speed/
frequency and pass code.
• Group 20: LIMITS – Defines minimum and maximum limits
for driving the motor.