CAN Bus accessories
Section 4 Accessories
66
M&I – AC 900F Controller
CAN Bus accessories
Different accessories are needed, depending on the controller configuration
(single/redundant) an the location where the controller is connected to the CAN bus
of the Freelance I/O racks. Refer to
for details about the
connection variants.
TP 910F CAN Bus termination plug
CAN TP 910F_us.png
Features
•
CAN Bus termination, triple
•
Integrated terminating resistors (cannot be deactivated)
•
D-SUB connector, 9-pin, male (M)
•
6 screw terminals
•
Connection area for cable shield and strain relief
Use
The TP 910F termination plug serves for terminating (with correct impedance level)
three CAN bus lines directly at the CI 910F CAN Bus interface module.
The screw terminals in the plug allow to connect either the TK 811F open-end CAN
cable or a commercial twisted-pair cable.
Summary of Contents for AC 900F
