ab Solares Smart Spa, Operating Manual

Page: 35 / 40

Solares™ Smart Spa Bathing System Operating Manual
CD0036 - 35 - 1121
4. If you filled the tank all the way, then you
can write down the reservoir
temperature shown in the top left of the
bathing screen. Otherwise, you will need
to collect the temperature from the
inputs page under maintenance.
5. If you have a probe that you can drop
down into the reservoir to measure the
water temperature, then you can use it
and write down the current temperature
of the water. If you do not have such a
probe and have calibrated the tub’s
thermometer then you can just use the
filling temperature displayed on the
bathing page. This is not as accurate as
measuring directly but should be
sufficient if this is not an option.
6. Go to the maintenance screen and hit
“Calibrate Res Thermistor.”
7. When the calibration dialog box comes
up, tap on the number next to
Temperature Reading on HMI. Enter the
filling temperature that was shown on the
HMI when you measured the water
temperature.
8. Press the number next to Measured
Temperature Reading and enter the value
you measured with your thermometer.
9. Press OK to complete calibration.
10. Steps 1-4 should be repeated to verify
that the calibration was successful. If the
displayed temperature and the measured
temperature are not in line, you will need
to repeat the procedure.
Package Configuration
The package configuration screen enables and
disables the tub’s accessories in the program .
When an accessory is disabled; all its buttons,
pages, and options are hidden from view.
Options should never be set to enabled if the
tub is not equipped with the option as it will
add confusion for the operator.
Rapid Fill ™ Reservoir Package – Enables
operation of the reservoir. Should be set to
“On" if the tub is equipped with a reservoir.
™ UV Package – Enables UV lamp
operation. Should be set to “On” if the tub is
equipped with Remedy ™ .
Scale Package – Enables scale operation.
Should only be set to “On” if the tub is
equipped with a scale.
I/O Screens
The I/O screens display the status of the
system
’ s various inputs and outputs to aid in
troubleshooting.
Input Screen:
The inputs screen can be accessed by clicking
the I/O button on the maintenance screen.
The inputs screen displays the status of all the
tub’s inputs. The inputs on the left are the