AAVIX AGT1424S, Owner'S Manual

Page: 25 / 33

25
not insert the ignition key in the hole
2. Drain out the oil. Otherwise, the oil
could come into the piston during
transportation, engine cannot start.
3. Switch off the fuel.
4. Protect the product from any heavy
impact or strong vibrations which may
occur during transportation in vehicles. before assembly before transporting it
anywhere.
5.Do not try to carry the product alone!
Only transport it pushing forward. If it is
necessary to lift the product ask another
person for help.
6. Secure the product to prevent it from
slipping or falling over.
Troubleshooting
Suspected malfunctions are often due to causes that the users can fix themselves.
Therefore check the product using this section. In most cases the problem can be
solved quickly.
WARNING! Only perform the steps described within these instructions!
All further inspection, maintenance and repair work must be performed
by an authorized service centre or a similarly qualified person if you
cannot solve the problem yourself!
Problem Possible cause Solution
1. Engine does
not start
1.1. Not enough fuel in fuel
tank
1.1. Add fuel
1.2. Primer has not been
pressed at cold start 1.2. Press the primer and
restart
1.3. Primer has been
pressed at warm start
1.3. Dry spark plug
1.4. Spark plug is wet 1.4. Dry spark plug
1.5. Spark plug is damaged 1.5. Replace spark plug
2. Engine stops
2.1. Not enough fuel in fuel
tank
2.1. Add fuel
2.2. Auger is blocked 2.2. Remove blockage
3.
Unsatisfactory
result
3.1. Auger damaged, worn
or bent
3.1. Have it replaced
3.2. Impeller blocked 3.2. Remove the blockage
3.3. Auger/chute blocked 3.3. Remove the blockage
3.4. Shear pin broken 3.4. Replace it
4. Excessive
vibration/noise
or exhaust
4.1. Auger is damaged 4.1. Have it replaced
4.2. Auger is blocked 4.2. Remove blockage
4.3. Screws/nuts are loose
4.3. Tighten the screws/
nuts
4.4. Fuel is incorrect or the
wrong oil has been used 4.4. Empty out unused fuel
and refill with the correct
fuel/oil