AAVIX AGT1424S, Owner'S Manual

Page: 19 / 33

19
product for damage. Repair or replace
any damaged part before restarting and
operating the product.
2. Keep children, pets, and bystanders
away from the area of operation. Be
aware that the normal noise of the
product when turned on may make it
difficult for you to hear approaching
people.
3. Pay attention to the wind direction. If
possible, move in the same direction as
the wind so that the snow is not thrown
against the wind (and thus back into
your face and on the just cleared path).
4. Do not push the product with
excessive force. You should push the
product gently and evenly in accordance
with the products throw rate.
5. Some parts of the product may freeze
under extreme temperature conditions.
Do not attempt to operate the product
with frozen parts. If the parts freeze
while the product is in use, stop the
product, switch off and disconnect from
the power supply, and inspect for frozen
parts. Free all parts before restarting or
operating the product. Never force
controls that are frozen.
Turns
Use the forward and reverse gears
respective to turn the product.
After use
1. Switch the product off as described
above, disconnect the spark plug
connector and let it cool down.
2. Check, clean and store the product as
described below.
Maintenance
The golden rules for care
WARNING! Always switch the
product off, disconnect the
spark plug connector and let
the product cool down
before performing
inspection, maintenance and
cleaning work!
1. Keep the product clean. Remove
debris from it after each use and before
storage.
2. Regular and proper cleaning will help
ensure safe use and prolong the life of
the product.
3. Inspect the product before each use
for worn and damaged parts. Do not
operate it if you find broken and worn
parts.
WARNING! Only perform
repairs and maintenance
work according to these
instructions! All further works must
be performed by a qualified
specialist!
General cleaning
1. Clean the product with a damp cloth.
Use a brush for areas that are hard to
reach.
2. In particular clean the air vents after
every use with a cloth and brush.
3. Remove stubborn dirt with high
pressure air (max. 3 bar).
NOTE: Do not use chemical,
alkaline, abrasive or other
aggressive detergents or
disinfectants to clean this product as
they might be harmful to its surfaces.
4. Check for any damage and wear.