Aastra Ascotel IntelliGate 2025, System Manual, Page: 82 / 111

Interfaces and Terminals as of I7.8
82 Terminals
sy
d-
023
9/2.
4
– I7.
8
– 0
7
.2009
3. 6. 1. 2 Office 25, Office 35, and Office 45/45pro
These terminals are desktop models. A wall-mounted bracket is available as an op-
tion for Office 25 and Office 35.
Installation of the desktop model
Connect the handset cord and the phone cord to the terminal as indicated in the
operating instructions.
Installation of the wall-mounted bracket (Option)
The wall assembly set consists of a baseplate, a wall plate and fastening screws (see
Fig. 40 ).
1.
Secure the wall plate to the wall using the three longer screws. Feed the cord
through the middle opening on the wall plate (see
➀
).
2.
Remove the 4 plastic feet on the underside of the terminal (see
➁
).
3.
Secure the baseplate of the wall assembly set to the underside of the terminal
using the 2 shorter screws (see
➂
).
4.
Suspend the baseplate with the terminal onto the wall plate from above (see
➃
)
and tilt downwards until it snaps into place (see
➄
).
5.
Plug the phone cord into the terminal (see
➅
).
Connection
1.
Set the AD2 bus address under the terminal's designation label.
– TSD1 = Address switch not pressed (disengaged)
– TSD2 = Address switch pressed (engaged)
2.
Plug the connector into the socket-outlet.
3.
If the system is configured, test the operation of the terminal.
4.
Label the terminal as indicated in the operating instructions.
Expansion keypad EKP and alphanumerical keyboard AKB
The connection of the expansion keypads and the alphanumerical keyboard to
Office 35 and Office 45 is described in the relevant operating instructions.
Power supply
The terminals are powered via the AD2 line (exception: Office 45pro).