Installing the application card
11
Applications Card CPU2
syd-0421/1.2 – R2.1 – 07.2012
Putting the application card into operation
To put the application card into operation, proceed as follows:
1. Switch on the communication server.
Switching on the communication server also powers up the application card.
You can see this on the the LED's On/Off key which now turns steady orange.
2. From your administration PC, open your communication server's WebAdmin
and log on.
3. Navigate to the card window (
Configuration
/
System
/
Cards and Modules
.
The application card is now entered in slot 2 under the name
CPU2
, and the
operating status
is
Available
.
4. Click the
Confirm
button at the end of the slot line.
The application card is now registered on the communication server. The
operating status changes from
Available
to
In operation
. On the WebAdmin
menu tree, on the uppermost level after the
Configuration
menu, the
Multimedia
menu is displayed.
5. Start the application card, by pressing the On/Off pushbutton on the card.
6. Starting the application card is similar to starting a computer, and may take a
while. The On/Off pushbutton LED turns green after the booting process and
individual windows in the Multimedia menu are now accessible.
Configuring the application card
Below, you can check the communication server IP address, choose a password for
the application card and load the licence data for OIP and TWP. A setup wizard will
guide you through the configurations:
1. Open the
Multimedia
/
Basic configuration
window and check under
Current IP
address
whether your communication server IP address has been entered
correctly.
If this is not the case, the setup wizard has probably detected other
communication servers on your subnet. You can see all the IP addresses of
detected communication servers under
Communication servers in subnet
.
Choose the IP address of the right communication server and click the button
<<
, to confirm it. Alternatively, you can also enter the correct IP address
manually.
Warning:
If you wish to change your communication server and application card
IP address later, you must first change your application card IP address!