Installing the application card
10
Applications Card CPU2
syd-0421/1.2 – R2.1 – 07.2012
Installing the application card
Installation consists in fitting on and starting the card. Start the installation
process only after putting the communication server into operation.
Preparing the application card installation
Before installing the application card, first make the following preparations:
1. First put the communication server Aastra 470 into operation and configure
your system for operation without application card.
2. Configure the Windows user name and the users e-mail addresses.
3. Assign users the required CTI applications.
4. Create a backup of the configuration data.
5. Switch off the communication server.
6. Check the communication server IP environment with regard to the following:
Note:
There should be no other communication server with installed
application card on the communication server subnet.
Installing the application card
To install the application card on the communication server, proceed as follows:
1. Unscrew the screw on the larger dummy cover in slot 2 and remove the cover by
pulling the screw.
2. Remove the plastic cover of the narrow dummy cover in slot 2. To do so insert a
screwdriver at an angle from below to release the snap-in mechanism on the
plastic cover.
3. Unscrew the screw on the narrow dummy cover and remove the cover by
pulling the screw.
4. Carefully slide the application card into the shaft of slot 2 and gently press the
card as far as it goes into the connection on the backplane.
5. Use the screw to secure the card in its slot.
The application card is now installed.