5
2
-
1
Display
z
Displays the weighing data and the unit (or mode) received. The unit (or mode) may be different from
that of the weighing instrument.
z
Turns on the stabilization indicator when the header of the weighing data received is "ST", "QT", or
"WT".
z
Turns on the comparator indicator when the comparison results are added to the data received.
Applicable to GX-K, GF-K, GP and AD-4212. (Function setting "
Cp-r
")
z
When nothing has been received for two seconds or more, the bar display [- - - - -] appears. By
changing the function setting, the previous data received is displayed until the next data is received
(Hold display). During the hold display, the hold indicator is turned on.
Note:
When the data is in eight digits, the highest-order digit is displayed in the upper
left corner as shown below.
For example, if the weighing data is 101.00000 g, the display is like .
2
-
2
Key Operation
Available key operations to control the weighing instrument depend on the weighing instrument used. For
details, see Table 2 in " 1-2 Applicable Instruments".
Set the command set "
C5et
" of the function setting, appropriate to the weighing instrument.
To enter the function setting mode of the AD-8922, press and hold the ON:OFF key and press the CAL
key.
The weighing instrument has its own function settings and the AD-8922 can not change those settings.
2
-
3
Connectors
2
-
3
-
1
Connector to the weighing instrument (BALANCE / SCALE) ... D-Sub 9-pin male
Used to connect to the weighing instrument. The cable used for connection depends on the instrument.
For details, refer to the instruction manual of the weighing instrument.
2
-
3
-
2
Connector to the external device (PC / PRINTER) ... DIN 8-pin female
Used to connect to an external device such as a personal computer or a printer (AD-8121B). The cable
used for connection depends on the device. For details, refer to the instruction manual of the device.