®
Aluminum Athletic Equipment
1000 Enterprise Drive, Royersford, PA 19468
Toll Free: (800) 523-5471 Phone: (610) 825-6565
www.aaesports.com
10'-0"
120"
from
Ground
Level
Debris Ring
(Optional)
If not present
Make sure
lower collars
are positioned
accordingly.
Net Pulley
System
Right
View
Post Cap
pre-installed
3'-6"
42"
(REF)
+
Height
of
Fence
or
Wall
Front
View
Corner Post Vertical
Cable needs to be
run in front of net.
Do Not Secure to
Lower Vertical
Tensioner until net
has been raised
and fully tensioned.
Cleat
Detail
6
10
7
1
9
9
Apply
supplied
Anti-Seize
to bolt
threads
Eyebolt
Detail
3
4
5
Apply supplied
Anti-Seize to bolt
threads
Open
Eyebolt Collar
Detail
40.00°
Cleat
(for positional ref)
Warning
Label
AAE I.D.
Label
Installation Notes:
Lower Collar(s):
From bottom of pole slide the
1.
lower horizontal collar and and debris ring
(
optional
) into position. To allow proper
insertion into ground sleeve, lower most collar
should be 42" + Height of Wall/Fence from end
of post.
Before securing collars into place verify
correct orientation.
(
refer to diagram
)
Cleat:
Is to be installed so that it is on backside
2.
of post, opposite net. Screws will be inserted
through post and cleat and secured on opposite
of net side using self locking hex-nuts and cap
nuts. (
refer to diagram
)
Mid Collar Open Eyebolt:
Note orientation of
3.
collar on post. From top of pole slide the open
eyebolt collar into position (
refer to diagram
)
and secure into place.
Mid Collar with Shackle:
Note orientation of
4.
collar on post. From top of pole slide the open
eyebolt collar into position (
refer to diagram
)
and secure into place.
Eyebolt:
Pulley system comes preassembled to
5.
eyebolt. Install washer onto eyebolt then insert
eyebolt with washer through front side of hole at
top of post. From opposite side secure eyebolt
into place using a flatwasher and self-locking
hex-nut. (
refer to diagram
)
Upper Collar:
From top of pole slide the upper
6.
vertical cable collar into position (collar should
rest on eyebolt washers).
Before securing
collars into place verify correct orientation
.
(
refer to diagram
)
Make sure warning labels are present on goal
7.
posts.
Note:
Post assembly should be
done with post laying down
on flat level surface.
Note: Collars are Black in color,
shown in different colors to aid in
identification.
Anti-Seize
(supplied by AAE
Collar Orientation
Detail
(Note:
ONLY
vertical cable
collars should be turned away
from netting, this aids in
tensioning the net)
BBS-25/FA & /WA
Assembly Instruction
Right Corner Post
17 of 25
