®
Aluminum Athletic Equipment
1000 Enterprise Drive, Royersford, PA 19468
Toll Free: (800) 523-5471 Phone: (610) 825-6565
www.aaesports.com
3'-6"
42"
(REF)
10'-0"
120"
Net Pulley
System
Right
View
Post Cap
pre-installed
Lower Horizontal
Cable Collar
w/ Pear Clip
Front
View
Debris Ring
(Optional)
If not present
Make sure
lower collars
are positioned
accordingly.
Cleat
Detail
6
10
7
1
9
9
Apply
supplied
Anti-Seize
to bolt
threads
Eyebolt
Detail
3
4
5
Apply supplied
Anti-Seize to bolt
threads
Collar Orientation
Detail
(Note:
ONLY
vertical cable collars
should be turned away from netting,
this aids in tensioning the net)
Pear Clip
Collar
Detail
AAE I.D.
Label
Warning
Label
Cleat
(for positional ref)
Installation Notes:
Lower Collars:
From bottom of pole slide the
1.
lower horizontal collar and and debris ring
(
optional
) into position. To allow proper
insertion into ground sleeve, lower most collar
should be 42" from end of post.
Before securing
collars into place verify correct orientation.
(
refer to diagram
)
Cleat:
Is to be installed so that it is on backside
2.
of post, opposite net. Screws will be inserted
through post and cleat and secured on opposite
of net side using self locking hex-nuts and cap
nuts. (
refer to diagram
)
Mid Collar with Pear Clip:
Note orientation of
3.
collar on post. From top of pole slide the open
eyebolt collar into position (
refer to diagram
)
and secure into place.
Eyebolt:
Pulley system comes preassembled to
4.
eyebolt. Install washer onto eyebolt then insert
eyebolt with washer through front side of hole at
top of post. From opposite side secure eyebolt
into place using a flatwasher and self-locking
hex-nut. (
refer to diagram
)
Upper Collar:
From top of pole slide the upper
5.
vertical cable collar into position (collar should
rest on eyebolt washers).
Before securing
collars into place verify correct orientation
.
(
refer to diagram
)
Make sure warning labels are present on goal
6.
posts.
Note:
Post assembly should be
done with post laying down
on flat level surface.
Note: Collars are Black in color,
shown in different colors to aid in
identification.
Anti-Seize
(supplied by AAE
BBS-25/SA
Assembly Instruction
Inner Post
12 of 25
