®
Aluminum Athletic Equipment
1000 Enterprise Drive, Royersford, PA 19468
Toll Free: (800) 523-5471 Phone: (610) 825-6565
www.aaesports.com
Crimped
Cable End
(pre-assembled)
Large
Eyebolt
Right End Post
Assembly
Inner Post
Assembly
Small
Eyebolt,
4' Spacing
entire
length of
cable
Corner Post
Assembly
Large
Eyebolt
Left End Post
Assembly
Clamped Loop End
Detail
Thimble
(
must be present
)
Cable Clamp Loop
must be on cut end of cable
After cable has
been fully
tensioned trim
back cut end and
wrap with tape
Vinyl jacket must
be stripped from
cable loop end
Support
Cable vinyl
jacket
Installation Notes:
Refer to collar assembly diagram for further detail on collar and cable
1.
assembly.
Install Crimped Cable End to Right End Post Large Eyebolt
using an
2.
anchor shackle.
Route cable to Left End Post. Make sure to route cable thru Small &
3.
Large Eyebolts installed to top of wall.
Before assembling Clamped Cable Loop End, fully open the
4.
turnbuckle.
With anchor shackle and thimble inplace run cable thru the shackle as
5.
shown. Pull slack out of cable and mark vinyl sleeve approximately 4"
from thimble end. Strip vinyl from mark location towards cable loop
end.
With the slack still being pulled out of cable install and secure the
6.
cable clamps. The first clamp should butt upto the thimble, the second
should be spaced approx. 1" on center from the first. Cable clamps
must be gripping bare cable to ensure proper seating/grip.
Note: Collars are Black in color,
shown in different colors to aid in
identification.
BBS-25/WA
Assembly Instruction
Lower Horizontal
Support Cable
22 of 25
