A-Trend ATC-5030, Manual

Page: 30 / 59

2-6 IDE DRIVER INSTALLATION
Setup for Windows 95 : (Windows 95 version 950/950a/950b)
1. Starting Windows 95
2. Select “START”, “RUN”.
3. Install INF.EXE before you install IDE driver, please refer to
readme file.
4. Type “A:\WIN95\SETUP.EXE”.
5. Restart computer, then follow the instructions on your
screen to install new IDE driver we offer in the 3.5“ diskette
6. Exit Windows 95, turn power off; then turn power on.
After installation, the screen will show a yellow
！
, please ignore it.
(The other platforms please refer to readme file.)
Make sure your HDD should follow ATA standard, and your CD-
ROM should follow ATAPI standard. When you plug-in the IDE
devices, please plug your first and second devices into IDE 1 port
(Master then Slave), then plug third and forth devices into IDE 2
port. If you have CD-ROM drive, please set it behind hard disk
devices as the last device. For example, if you have 2 HDDs and 1
CD-ROM, you should set HDD1 and HDD2 in IDE1 Master and
Slave, set CD-ROM in IDE 2 Master. Some of the brands devices
combination may not work under this sequence, you can try to re-
arrange the devices sequence, or contact your vendor.
30
Primary
Master
Primary
Slave
Secondary
Master
Secondary
Slave
ATA no ATAPI
ATA ATAPI disk & CD-ROM
ATA ATAPI use only one cable
ATA ATAPI ATAPI
CD-ROM and a tape
or two CD-ROMs