![background image](http://html1.mh-extra.com/html/a-j-antunes/vct-200-series/vct-200-series_manual_3146334008.webp)
RAPID TOASTER VCT-200
8
P/N 1010710 Rev. N 02/13
McDonald’s
Pressing the TEMP UP key will display the current
platen temperature provided it is over 420°F (216°C).
Pressing the TEMP DOWN key will display the
current auxiliary heaters temperature when it is
over 250°F (121°C).
Pressing and holding TEMP SCALE key for 3-5 sec-
onds will switch the temperature display between
Fahrenheit (°F) and Celsius (°C).
RECOMMENDED TEMPERATURES
Recommended temperature setting for the platen heat-
er is 560°F (293°C).
Recommended temperature setting for the auxiliary
heaters is 400°F (204°C).
NOTE: The toaster is tested and shipped with the
heaters set at the above recommended tempera-
tures.
PLATEN SETPOINT TEMPERATURE ADJUSTMENT
1. Turn power switch on and wait for temperature
display to finish the power up sequence (Figure
4).
2. Press and hold both TEMP UP and TEMP DOWN
keys until the display flashes the platen setpoint
temperature, then release.
3. Press the TEMP UP or the TEMP DOWN key
to raise or lower the setpoint temperature.
The setpoint temperature will adjust 1° every
0.1 seconds.
4. Release the key when the desired setpoint is
displayed.
NOTE: Maximum adjustable setpoint temperature
for the platen is 600°F (315°C).
NOTE: If no change is made within 5 seconds, the
display will revert back to the previous setpoint.
AUXILIARY HEATER TEMPERATURE ADJUSTMENT
1. Turn power on and wait for temperature display to
finish the power up sequence (Figure 4, #3 & 4).
2. Press and hold both TEMP UP and TEMP SCALE
keys until the display flashes the auxiliary setpoint
temperature, then release (Figure 4, #3)
3. Press the TEMP UP or TEMP DOWN key to raise
or lower the setpoint temperature. The setpoint
temperature will adjust 1° every 0.5 seconds.
4. Release the key when the desired setpoint is
displayed.
NOTE: Maximum adjustable setpoint temperature
for the auxiliary heater is 400°F (204°C).
TEMP
UP
TEMP
DOWN
TEMP
SCALE
˚F
˚C
POWER
TEMP
UP
TEMP
DOWN
TEMP
SCALE
˚F
˚C
POWER
sp-p
560
TEMP
UP
TEMP
DOWN
TEMP
SCALE
˚F
˚C
POWER
TEMP
UP
TEMP
DOWN
TEMP
SCALE
˚F
˚C
POWER
400
sp-a
Figure 4. Temperature Power Up Sequence
3. SP-A (Setpoint Auxiliary)
is displayed
1. SP-P (Setpoint Platen)
is displayed
“Heat On” LED will blink on/off during warm-up and when
either platen or auxiliary heaters are calling for heat.
2. Current Platen Temperature
setting is shown
4. Current Auxiliary
Temperature setting is shown
5. “LO” is displayed until
platen temperature rises
above 520°F (271°C)
6. “USE” is displayed when
Platen Setpoint Temperature*
is reached
TEMP
UP
TEMP
DOWN
TEMP
SCALE
˚F
˚C
POWER
lo
TEMP
UP
TEMP
DOWN
TEMP
SCALE
˚F
˚C
POWER
use
* Platen setpoint temperature must be between
520°F (271°C) and 590°F (310°) for “USE” to be displayed.
OPERATION (continued)