28
NCORE MANUAL
VER. 2 REV. 1
Command line interface
The SSH interface allows you to control some accessible parameters of the NCore, configure communication, read error
messages, update the software and force some of the actions listed in a later paragraph.
Access
To access from the terminal, type the following command line: ssh admin@<número IP>
The first time we log in to the SSH interface, it will ask us if we accept the connection key certificate. Showing an image
like the following:
Once we have accepted with the word "yes", the next times we connect with the same IP, it will assume that it is a reliable
IP address and will not ask for it again. To inform us of this, it will show us a message like this:
Indicating that the IP address has been permanently added to the list of known hosts. After that, it will ask us for the
password, and we must enter the default one: "password"
As soon as you log in, the 9dot logo will appear as shown below:
To see all possible menus and commands, type "?" and press "enter".
IMPORTANT NOTES
It is recommended that you change the default password the first time you log into the interface.
To cancel any configuration or command in progress, press “Ctrl + C”.
Summary of Contents for NCORE
Page 1: ...1 NCORE MANUAL VER 2 REV 1...
