STEP 14
To complete the trigger slot remove all the top plates and the template
spacer. Clear away chips from the lower and side plates. Reinsert and tighten
the Rear Jig Bolt #08. Place the Trigger Pocket Template #05 on the jig
with the depth gauge facing down. Attach the Trigger Pocket Template #5
to the jig side plates, inserting only the 2 short Trigger Milling Bolts #10 into
the two holes on the template closest to the buffer tub. Use the two jig wall
screw holes furthest away from the buffer tube to secure the template.
Secure the Jig into the vise. Using the 19/64” drill #15, slowly drill the pilot
hole.
WARNING:
Use very little downward force when drilling the pilot hole.
It is possible to drill past the bottom of the trigger area and into the trigger
guard below if pressing too hard. Make sure to go slowly and control the
downward pressure at all times.
TIP:
If you are using a hand drill, it’s important that you drill the pilot hole
very straight. Do not drill at an angle or the pilot hole may drift outside the
boundary of the trigger slot template. Use a punch, if available, to further
prevent the drill bit from walking when you start drilling. Use very little
downward force and go slowly when drilling the pilot hole to prevent
the drill bit from walking.
-
13 -
Summary of Contents for AR-15 Easy Jig
Page 1: ...AR 15 Easy Jig MANUAL...
