41
Ethernet Settings Tab
Once you have connected to a Data Collector, as described in the section titled
Connecting to a Data Collector on page 36, you can edit the Ethernet settings of the
Data Collector by following these steps:
1. Click on the Data Collecto
r’s Site Name in the Data Collector’s status summary.
2.
Click on the ‘Ethernet Settings’ tab in the right pane.
This will make the Ethernet Settings panel appear as shown below.
The Ethernet settings section allows you to specify how the Data Collector will connect
to a Local Area Network (LAN) if available.
Host Name
– This specifies the hostname of the Data Collector as used in name
resolution. (If unsure, use the default value).
Use DHCP to obtain IP Address
– If this option is selected, then the Data
Collector will use the DHCP protocol to automatically fetch an IP address. (If
unsure, select this option)
Use a Static IP Address
– If the LAN does not have a DHCP server or your
application requires a fixed IP address, then select this option and enter each of
the IP networking parameters. Contact your network administrator if you are
unfamiliar with these settings.
IMPORTANT:
If unsure, please contact your network administrator to verify these
settings before connecting the Ethernet jack.
Summary of Contents for Antenna W.A.S.P.
Page 1: ...Antenna W A S P User s Guide...
Page 5: ...5 CE Mark Conformity...
Page 59: ...59 Technical Support Contacts...
